Search results

the front DS has 107k miles on it, from a 4wd 2000, ran fine when I swapped it out for custom $50 heater core no leaks, just decided to swap it for new with evap replacement $20 factory t-case output shaft to rear NP-231, good condition, $30 pics here...

Curious to know how many folks run these on the trail.

AT's or MT's, with decent tread (not looking for rollers)

MaxxXJ can you post a front view pic, want to see how much they hangover on sides, thanks

Tire Metro in Garden Grove will do 33x10.50r15 in BFG AT's for $780 or KM2's for $820 mounted and balanced

how did yo like the 10.5's, they look narrow, but i am considering them for less rubbing and lighter weight

already took front ds out and yes vibes are gone when driving. Trying to determine problem on ds is it the angle, the yoke (1/16" of play) or the u-joints? IS the slip yoke supposed to have any play?

Can about 1/16" play in front ds slip yoke cause vibration at highway speeds? I am runnings 32's with 4.56 gearing so that sucker is spinning good. done a lot of searching, could not find a specific response, thanks

just curious why the sell, it just put one of these in and it great

that camp spot looks nice

Hate to change subjects but where was the jeep in those pics?

i would vote no on the spring wrap, i have new RE spring pack not related. lubing all my points on the drive train solved the problem.

the tranny mount is the single rubber one on the frame to frame support?

Its not the SYE i have one and still have the problem. If you put it in Nuetral and rev the engine that would tell you if its motor mounts right?

So I got a P0204 and P0304 codes for injector failure and cylinder misfire. I went to move injector #4 to another cylinder just to test to make sure it was a bad injector. Funny thing was when I started up the engine after moving the injector I don't get get anymore codes? Can something I did...

my story about the $5oo to replublic of Congo was a joke, I think people believing me was funnier than actaully sending money overseas...

I bought one for $500 from Umbenga Ubuntu, I sent him the money and he promised to send it to me via cargo ship landing in Long Beach, still waiting for it to arrive. Perhaps it took a while for the money to reach the Republic of Congo. It is hard to tell when it will arrive because he does not...

Emailed him and he gave me some advice, but what i've found I need to do is slice out a cut-off wheel's width all the way down the line and re-weld the tube back together. I have spent 6 hours on it already and that is only the passenger side. I thought maybe it was just the driver side, and...

Left side does not fit. Talked to someone on email but gave up. guess i am on my own probably have to butcher a chunk out of the tube because the plate does not seat flush on the front bolt. Have not tried the right side yet.

expensive as brushwackers though, i want lower budge