i am planning on upgrading my 87 dana 30 disco 260 u-joints to non-disco 297 u-joints.
Question #1 do i use the same unit bearing that are in my axle or do i need to use a different outer knuckle?
Question #2 what seals do i use?
Question #3 I have read that i need to remove the gears w/ carrier and press in new seals or can i just remove the vaccum disconnect pull the seal and press in new seals through that and NOT remove the carrier?
Question #1 do i use the same unit bearing that are in my axle or do i need to use a different outer knuckle?
Question #2 what seals do i use?
Question #3 I have read that i need to remove the gears w/ carrier and press in new seals or can i just remove the vaccum disconnect pull the seal and press in new seals through that and NOT remove the carrier?