RWKHausSupply
NAXJA Forum User
- Location
- yorba linda, Cali
Well been accumilating parts for the dana 60 front and 14bolt rear.
Front to be rockjock III based on the Dana 60 HP
Currie doing the center section cut for TJ/XJ fitment on housing and 3"od tubes,I will cut it to set at aprox 66" wms
ARB
5:38 gears
35 spline Dutchman 4340 custom length inner axles
35 spline Yukon 4340 outer ford axles
stock spicer ujoints
1350 billet yoke
Dedenbear king pin Inner C's
Tanked and painted Ford knuckles, spindles and caliper brackets
New dual pistion ford calipers and rotors
Staying 8 lug
35 spline drive slugs
balistic fab, spring and LCA brackets with shock mounts incorporated
KOZ high steer pass side arm
Rear 14 bolt from 75 (ish) 1 ton stock 30 spline 66.5"WMS (i know 67" is what its supose to be)
Detroit
5:38 gears
1350 Ubolt yoke
Ruffstuff caliper brackets
New chevy calipers and rotors
staying 8 lug
GLO pinion skid
TNT ubolt elim. in a 1.5" lift
Then got some 325/80R16 xterrains for now and looking for some steel 16" rims and going to do DIY beadlocks. Going to lift it about 2" also front (ACOS) and rear (ubolt elim.).
Hoping to get this done and bring it for its first on dirt trip to big bear on the 4th of may, will see though.
still awaiting lots of parts in the mail though, but heres some pictures..
before paint
These things are huge.. well compared to my D30 and what I am used to.
Front to be rockjock III based on the Dana 60 HP
Currie doing the center section cut for TJ/XJ fitment on housing and 3"od tubes,I will cut it to set at aprox 66" wms
ARB
5:38 gears
35 spline Dutchman 4340 custom length inner axles
35 spline Yukon 4340 outer ford axles
stock spicer ujoints
1350 billet yoke
Dedenbear king pin Inner C's
Tanked and painted Ford knuckles, spindles and caliper brackets
New dual pistion ford calipers and rotors
Staying 8 lug
35 spline drive slugs
balistic fab, spring and LCA brackets with shock mounts incorporated
KOZ high steer pass side arm
Rear 14 bolt from 75 (ish) 1 ton stock 30 spline 66.5"WMS (i know 67" is what its supose to be)
Detroit
5:38 gears
1350 Ubolt yoke
Ruffstuff caliper brackets
New chevy calipers and rotors
staying 8 lug
GLO pinion skid
TNT ubolt elim. in a 1.5" lift
Then got some 325/80R16 xterrains for now and looking for some steel 16" rims and going to do DIY beadlocks. Going to lift it about 2" also front (ACOS) and rear (ubolt elim.).
Hoping to get this done and bring it for its first on dirt trip to big bear on the 4th of may, will see though.
still awaiting lots of parts in the mail though, but heres some pictures..
before paint
These things are huge.. well compared to my D30 and what I am used to.