JOSEJALAPENO
NAXJA Forum User
- Location
- SAN JOSE,CA & SOUTH RENO,NV
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
Why I won't be doing any wheeling this year.
- Thread starter EricsXJ
- Start date
zebvance
NAXJA Forum User
- Location
- College Station Texas
Jealous... that's all have to say.....
son? LOL. I'm twice the age of some people on here.
Figure of speech lol. I don't think you're quite twice my age, but could be close
- Location
- on the beach in Ocean View, VA
son? LOL. I'm twice the age of some people on here.
damn fine work, pops:shhh:
:laugh:
- Location
- Lafayette, CA
Keep up the good work Eric!
Ive always been impressed with how clean and functional your fabrication has been in years past, and this project looks to be no different. :yelclap:
Ive always been impressed with how clean and functional your fabrication has been in years past, and this project looks to be no different. :yelclap:
- Location
- Reno, Nevada
Thanks - hopefully we'll get to wheel again when I get this thing done.
twodoorXJ
NAXJA Forum User
- Location
- northern new jersey
Love the way your tank relocation turned out. Nice job!
Vanimal
NAXJA Forum User
- Location
- escondido, ca
lookin good!
kmanxj5050
NAXJA Forum User
- Location
- Reed City Michigan
Awesome build. I envy your skills!
Jeepguy03
NAXJA Forum User
- Location
- Connecticut
Jeep looks great! Awesome fabrication.
Mpeckham22
NAXJA Forum User
- Location
- MA/NC
this is awesome, subscribed
- Location
- Reno, Nevada
Time to do a little body work:
Then I made some quarter panel guards out of 3/16" plate to skin the sides and add some protection:
I used countersunk bolts and the bottom edge will be fully welded to the tube. This will also match my front fenders.
Then I made some quarter panel guards out of 3/16" plate to skin the sides and add some protection:
I used countersunk bolts and the bottom edge will be fully welded to the tube. This will also match my front fenders.
- Location
- Reno, Nevada
Capped the corners with some tail light boxes:
VAhasnoWAVES
NAXJA Forum User
- Location
- Lake City, Mi
like.
Voteban
NAXJA Forum User
- Location
- Lehi, Utah
Very very nice! I've looked through a lot of your tech posts over the years, read your book, and drooled at pictures of your XJ. I can't wait to see your rig finished!
(At least until the next stage, remember when your XJ was stock?)
:worship:
(At least until the next stage, remember when your XJ was stock?
):worship:
WAZZUXJ
SoCal_XJ FB
- Location
- Aurora, CO
Looking sweet!
- Location
- Reno, Nevada
Thanks for the comments.
- Location
- Encinitas, Ca
Eric, results show you're putting thought into this! Your clean work area is impressive.
How are you cutting your plate? Plasma then clean up with grinder?
Jig saw? Cutting disk in grinder?
How are you cutting your plate? Plasma then clean up with grinder?
Jig saw? Cutting disk in grinder?
