There are two studs and two bolts holding the cross member on and I can't get the stud to come all the way out. I have it all the way unthreaded but now it's just sitting there spinning. Is there a nut in the frame rail or is it threaded?
On Yucca-Man's site he stated "Resist the urge to whack the nut and stud up into the frame since you'll need the nut again to bolt the t-case drop."
I'm running an SYE so no drop here and RE supplied 4 bolts to replace the 2 studs and existing bolts but I don't want to cut off and drill out the bolt if that's only digging a deeper hole.
Thanks...
On Yucca-Man's site he stated "Resist the urge to whack the nut and stud up into the frame since you'll need the nut again to bolt the t-case drop."
I'm running an SYE so no drop here and RE supplied 4 bolts to replace the 2 studs and existing bolts but I don't want to cut off and drill out the bolt if that's only digging a deeper hole.
Thanks...