Is there any kind of formula for how far to drop the transfer case? I only chose 1" as it seems to be the most popular size. But I have seen drops of .75". 1", 1.5", 2" etc.... Obviously I would like to keep it as small as possible without having to go thru alot of trial and error so I thought 1" seemed like a happy medium.
I have a rough country 3" lift on a 99 XJ. The leaf springs and fairly flat even with the add a leaf so Im not getting the full 3" lift in the rear, but would like to make sure my transfer case drop is signifcant enough for when I replace them with a new 3" spring packs.
I bought 2 inch long bolts. Im going to be using 1/2 inch nuts as spacers for the actual drop. Does anyone think that would cause a problem with stress distribution vs a length of aluminum or steel stock? I did see a drop kit on ebay that used what looked to be round poly pucks similar in setup to my using nuts.
I have a rough country 3" lift on a 99 XJ. The leaf springs and fairly flat even with the add a leaf so Im not getting the full 3" lift in the rear, but would like to make sure my transfer case drop is signifcant enough for when I replace them with a new 3" spring packs.
I bought 2 inch long bolts. Im going to be using 1/2 inch nuts as spacers for the actual drop. Does anyone think that would cause a problem with stress distribution vs a length of aluminum or steel stock? I did see a drop kit on ebay that used what looked to be round poly pucks similar in setup to my using nuts.