Lucas
NAXJA Forum User
- Location
- ZOO YORK CITY
So I found out my CA brackets on the axle end are FUbar and were 90% torn off. BUT, I discovered this at my parents place, far from a shop where I could repair/fab new ones. All I have to work with is a 4.5 inch angle grinder, a jigsaw, hand tools, and a borrowed miller. Do you think it would be "easy" to fab up new 3/16 inch brakets, or should I just order some pre-fabbed ones and burn them in next week?
Im just kinda getting into making my own parts, but I usually have a plasma or at least a torch at my disposa.
Im just kinda getting into making my own parts, but I usually have a plasma or at least a torch at my disposa.