dcampbell98XJ
NAXJA Forum User
- Location
- Western Connecticut
Over the weekend I replaced my unit bearings, and decided to replace ujoints at that time since I have no clue when they were last replaced. After pulling the axle out, oil started leaking from the tube so I shoved a rag in there. When I reinstalled everything the axle seemed to go in smooth without getting hung up. There is still fluid leaking out of the tube. The plastic or hard rubber seal in the end is not sealing. Do I need to upgrade and replace those factory seals? They are obviously old and worn out. I'm new to doing any drivetrain and axle work, so any guidance or advice is welcome.