- Location
- Hartsville, South Carolina
I need to replace my tie rod on the 60. Who can I get a cut and tapped length of tube from? I called Ballistic and they use tube and adapters.
He doesn't want tube and adapters, he wants it all to be one piece... makes sense to me.
I think your best bet is going to be getting the tube, then buying the taps used off someone in your chapter. I would bet on at least a set or two of them floating around the SEC, I know a couple of the NAC guys have them and some other common stuff like 1 ton end taper reamers.
what size tap?
any local machine shop wortha crud should be able to do it for ya
I have 24 ft of 1.25 .375 DOM, about 10 ft more than I need. I only have 3/4 left and right taps. If you need some tube let me know, i'll cut you a deal.
Cash for feet of tube.:laugh: Sounds kinda funny.
don't forget you'll need jamb nuts!