Kingkong0192
NAXJA Forum User
- Location
- New Milford, CT
If anyone has seen my posts about this topic on other websites, i apologize. I just need to have my jeep back together by tomorrow afternoon and i'm starting to stress out as the t-case/trans is still supported by a floor jack.
I bought a SYED (hence why i posted in Modified tech and not OEM) NP242 out of a 93 XJ. (I have a 99 XJ.)
Long story short, i dropped my case, and bolted it in. I still have the trans/tcase supported by a floor jack so i still have full access to everything.
I just need to know how to deal with the sensors. The 93 has two sensors both located towards the rear shaft area. My (99) has two sensors as well except one is located directly above the paddle shifter and then one on the rear shaft area. The actual connects are different so i can't just reach the plug over and plug it in. I think they're both different.
Is there an easy way to fix this? If not, i'm going to just ziptie them up somewhere and bolt everything up and drive the thing. I need it for tomorrow. I can't hold it off any longer.
Thanks a million.
I bought a SYED (hence why i posted in Modified tech and not OEM) NP242 out of a 93 XJ. (I have a 99 XJ.)
Long story short, i dropped my case, and bolted it in. I still have the trans/tcase supported by a floor jack so i still have full access to everything.
I just need to know how to deal with the sensors. The 93 has two sensors both located towards the rear shaft area. My (99) has two sensors as well except one is located directly above the paddle shifter and then one on the rear shaft area. The actual connects are different so i can't just reach the plug over and plug it in. I think they're both different.
Is there an easy way to fix this? If not, i'm going to just ziptie them up somewhere and bolt everything up and drive the thing. I need it for tomorrow. I can't hold it off any longer.
Thanks a million.