Truss clearance

I'm currently in the process of building a 8.8 for my XJ. I was just going to weld in the axle tubes and build a seperate anti-wrap mount when I surfed and saw the trusses. The way I see it I could use the top side of the truss to mount the top of my anti-wrap bar and put the lower mount on my axle tube. Does anyone see any problem with a truss of 2" tall x 3" front to back with the top plane being 2.5" above the "pig" and 6" wide (horizanal) coming down at 30* at both sides. I'm at 6" lift. At full compression, without cycling the rear I don't know if it will interfer with the floor pan.

p.s. I'm half way done with the truss.
TIA

Guy