mikerhyne
NAXJA Member # 1375
- Location
- Aurora, CO
I just finished rebuilding my Dana 35 to fix a bad pinion bearing and now I get a groan/vibration when I decelrate down to about 2-3 mph. When I rebuilt it I replaced all bearings and seals including the wheel bearings and new u joints in the rear drive shaft. I followed all of the instructions I could find and seemed like I had a good pattern and the prelaod on the pinion was a little light at about 20 in./lbs.
I'm going to tear back into it tomorrow but figured I check to see if anybody had an idea that would save me some time.
Thanks!!
Mike
I'm going to tear back into it tomorrow but figured I check to see if anybody had an idea that would save me some time.
Thanks!!
Mike