RWKHausSupply
NAXJA Forum User
- Location
- yorba linda, Cali
Well I have word and a few even available, of some new manufacture producing 300M ujoints comparable in design and same materials as Jacks at CTM.
I love all Jacks stuff, but these are said (dont know who tested or originally made the claim though) that these are stronger then CTM's?
They are currently avail for the D30/44 and D60 I am told... I been trying to get a picture of them. I should have something by later today.
I AM TOLD they are by Nitro.. but not confirmed yet...
Just got this:
The Excaliber Ujoint is 100% American made. The cross is made from heat treated billet 300M and the caps are 4340. The entire unit is heat treated and cryod for ulitmate strength and wear resistance. Joint comes with full circle clips and grease fittings that install into the caps. There are no needle bearings in these joints. This allows the legs for the cap to be thicker. These joints are for offroad use only and should be greased often. These are not to be run at high speed. It is the strongest joint on the market able to withstand over 150,000 lbs of force. These joints are backed with a lifetime no questions asked warranty. The trick is you have to break them.
I think pricing is about 160$ for D30/44 and 190$ for D60. So, they are alot more affordable. I am surprised it took this long to be done though...
I love all Jacks stuff, but these are said (dont know who tested or originally made the claim though) that these are stronger then CTM's?
They are currently avail for the D30/44 and D60 I am told... I been trying to get a picture of them. I should have something by later today.
I AM TOLD they are by Nitro.. but not confirmed yet...
Just got this:
The Excaliber Ujoint is 100% American made. The cross is made from heat treated billet 300M and the caps are 4340. The entire unit is heat treated and cryod for ulitmate strength and wear resistance. Joint comes with full circle clips and grease fittings that install into the caps. There are no needle bearings in these joints. This allows the legs for the cap to be thicker. These joints are for offroad use only and should be greased often. These are not to be run at high speed. It is the strongest joint on the market able to withstand over 150,000 lbs of force. These joints are backed with a lifetime no questions asked warranty. The trick is you have to break them.
I think pricing is about 160$ for D30/44 and 190$ for D60. So, they are alot more affordable. I am surprised it took this long to be done though...