Cottontail
Three-De Off-Road
- Location
- Nashville, TN
The RE lift instructions state they use a 3/8 inch center pin in the rear leafs, but because it is a stronger pin, it may be larger than the hole in the holder on the axle.
Sure enough, it is.
What do I use to enlarge the hole? I grabbed a 3/8th drill bit, but it is much tinier than the hole.
I did a search on this issue and the only thing I found was a thread with a suggestion to replace the pin in the new leaf pack to fit the existing hole.
Ideas?
Sure enough, it is.
What do I use to enlarge the hole? I grabbed a 3/8th drill bit, but it is much tinier than the hole.
I did a search on this issue and the only thing I found was a thread with a suggestion to replace the pin in the new leaf pack to fit the existing hole.
Ideas?