99+ Intake Swap Few Questions

ROBZ95Xj

NAXJA Forum User

Location

Keene NH

• May 17, 2007

• #1

im replacing the motor in my 95 XJ, i got a donor out of a 93, i have a intake off a 99 XJ, what esactly is needed for this swap, i know that ill need a ps bracket off a 96+ xj or 97+ tj do i need anything else?

 

OCMI_Teddy

NAXJA Forum User

Location

San Diego

• May 17, 2007

• #2

some extra tubing because the vacum slots are different sizes and in different locations.

 

C

CrazyXJ

NAXJA Forum User

Location

Tallahassee, Florida

• May 17, 2007

• #3

just have to use fuel rail off the 95some of the vac ports are dif. but that is easy to figure out

 

ROBZ95Xj

NAXJA Forum User

Location

Keene NH

• May 17, 2007

• #4

one other question, will my PS pump work? or will i also need to change that? thanks

 

BigG

NAXJA Forum User

Location

Michigan

• May 17, 2007

• #5

The IAT sensor line will need to be extended and a couple of vac lines will need to be branched together IIRC. GoJeep has a good write up for your model range.
http://go.jeep-xj.info/HowtoIntakeManifold1.htm

 

OCMI_Teddy

NAXJA Forum User

Location

San Diego

• May 17, 2007

• #6

BigG said:

The IAT sensor line will need to be extended and a couple of vac lines will need to be branched together IIRC. GoJeep has a good write up for your model range.
http://go.jeep-xj.info/HowtoIntakeManifold1.htm

Click to expand...

or you can just stick the IAT in you air tube. Alot easier than sodering and you get a little power increase from it. :clap:

 

P

Puddin99

NAXJA Forum User

Location

Scappoose, OR

• May 18, 2007

• #7

Get one of these for easy bolt on.

http://cgi.ebay.com/ebaymotors/97-01-Jeep-Cherokee-power-steering-bracket_W0QQcmdZViewItemQQcategoryZ33588QQihZ020QQitemZ300110075168QQrdZ1QQsspagenameZWDVW

Ken