WTB Pass side spindle for my 91 2WD MJ

[Russ Pottenger]

As the Post says, looking for a spindle for my shop truck.
The Jeep dealer tells me #53002932 spindle is out of stock and discontinued.
Checked all the parts stores including Napa.
No replacement made by Crown.

Let me know if you guys have or know of anything.

Thanks

 

[RWKHausSupply]

Well a very common alt.
Run a 4wd front knuckle with unit bearing, just make sure you run a a bolt and lock nut thru the axle spline area of the unit bearing or it will come apart. I think its a 1" or 1-1/8" bolt and nyloc works great. about 3" if I recall.

I am pretty sure you should do both sides though, if you go this route

 

[Russ Pottenger]

I'll keep this good option in mind if nothing comes up.

Thanks Robert

 

[Jays siik xj]

I havr a couple of those shafts that go through the hub that replaces the axle shaft so the hub doesn't come apart... Its splined like a regular axle shaft just flat on the back side instead of having the ears a 4x4 would have... Then you can run hubs no problem

 

[Jays siik xj]

I actually have hubs too... Pretty newish... you would have to change your rotor though.

 

[Russ Pottenger]

Just got hooked up.

Thanks Anthony and all that responded.

 

[Wiser]

Just got hooked up.

Thanks Anthony and all that responded.

No prob Russ, glad it worked out