Devilfrog
NAXJA Forum User
- Location
- Duncan, BC
So I had a broken bolt on my LP D30 yoke ... I tried drilling them out and it seemed OK until I went to put the nuts on ... no room.
I've tried searching but only found mention that you might have to grind the D30 yokes, nothing on how much.
I've also seen mention that the D35 has the same spline count and is essentially the same as the D44/30 but uses a differnet seal dimension.
I just so happen to have a turD35 going to scrap (grabbed it for the rear discs) ....
... can i use that yoke to replace my current D30 or should I bust out the grinder?
I will eventually replace the yoke (or the whole axle if I can find the right one).
I've tried searching but only found mention that you might have to grind the D30 yokes, nothing on how much.
I've also seen mention that the D35 has the same spline count and is essentially the same as the D44/30 but uses a differnet seal dimension.
I just so happen to have a turD35 going to scrap (grabbed it for the rear discs) ....
... can i use that yoke to replace my current D30 or should I bust out the grinder?
I will eventually replace the yoke (or the whole axle if I can find the right one).