Cisco Kid
NAXJA Forum User
- Location
- Kansas City, MO
First off here is a bit of info on my XJ. It is a 98 and has a 2 1/2" Superlift lift kit (installed by previous owner). This Jeep is my daily driver and most likely will not be taken off road because I don't want to be fixing broken stuff while trying to get out of debt. The problem I have is that the holes where the track bar bolts to the axle have been elongated from the bolt being loose. After spending the past few days searching on this site I have found alot of great information but would like some help with my particular situation. Should I go ahead and buy an adjustable unit to replace my stocker? If so what should I get? Do any of the aftermarket bars allow you to drill out the mount on the axle and use a 7/16" bolt instead of the stock 3/8" bolt?
If at all possible I would like to fix this correctly without drilling a new hole in the axle mount or using one of those cheesy relocating brackets. Cost is also being taken into consideration as well because I don't want a ton of money wrapped up in this. Thanks for any and all help and opinions. atriot:
If at all possible I would like to fix this correctly without drilling a new hole in the axle mount or using one of those cheesy relocating brackets. Cost is also being taken into consideration as well because I don't want a ton of money wrapped up in this. Thanks for any and all help and opinions. atriot: