Muddy Beast
NAXJA Forum User
- Location
- WA
I have a HF 90amp flux core welder, built my rear bumper over a couple months time and had pretty good luck. Got a lot of experience from that, and my weld held (it was the sole recovery point after I rolled we used). But I'm not sure what the technique is to weld the holes in the frame stiffeners?
I'm aware you have to clean, and prep is most of the work...but what about the actual welding? Does it matter much, other then not burning through the sheet metal? Do I take a swoop of "C" type welds around the circle, let it cool, and add more wire on top of that.
Thanks in advance! (oh, and I have a rig to practice on the "frames" with too)
~Scott
I'm aware you have to clean, and prep is most of the work...but what about the actual welding? Does it matter much, other then not burning through the sheet metal? Do I take a swoop of "C" type welds around the circle, let it cool, and add more wire on top of that.
Thanks in advance! (oh, and I have a rig to practice on the "frames" with too)
~Scott