benulis55
NAXJA Forum User
- Location
- pottsville, pa
Hey guys,
I have looked through every thread on here about dana 30 non-disco shafts in a disco housing and still have not found the correct seal #
CR 11771 is too small
my tube ID measures around 2.110"
I ordered a CR 11907 which is 2.129" OD and will try to make that work
is there anything else i can do? Can i takes seals out of my stock (non-disco) housing and make them work
i ripped the xj apart on Thursday to swap in 4.10 axles and install an RE 4.5 kit and this is holding me up
any advice is much appreciated
I have looked through every thread on here about dana 30 non-disco shafts in a disco housing and still have not found the correct seal #
CR 11771 is too small
my tube ID measures around 2.110"
I ordered a CR 11907 which is 2.129" OD and will try to make that work
is there anything else i can do? Can i takes seals out of my stock (non-disco) housing and make them work
i ripped the xj apart on Thursday to swap in 4.10 axles and install an RE 4.5 kit and this is holding me up
any advice is much appreciated