Is that an LT1 throttle body?
Yes, yes it is lol. This one was for a Camaro. I think it was like 89-93 or something. It took a while to search for this and I wish
I knew about it before the other intakes but oh well, chalk that one under experience lol. The first ones where setup differently
and the later ones had an incompatible TPS. Had to modify the linkage on this one a little to get full throw. It's flawless and
driveablility is ten-fold.
Ran a 70mm mustang throttle body for a while with a mercury 4.6 intake runner and that was okay. Far better than the stock but
the dual TB setup absolutely killed that setup and I ran that for a good while before but air leakage for the TB's was getting old but
then they weren't real TB's to begin with. They were just "idle bodies" that didn't seal worth a damn but everything the yard was a
tiny ass single TB aside from the TPI Camaros twin 48's that had their intakes robbed already lol.
I think when I had my fill with this TB I'll sell it and going to go with a big oval mono-blade TB. Better flow and will take better advantage
of my modded intake. The current creates a bit of a dead space just behind the TB but meh for now, it's the best setup so far. Best part
about that is that now it would be a bolt-on part.
I need a bigger filter though because I'm literally sucking the filter white. I tried without a filter to see the difference the response
became incredibly snappy but no real power till higher in RPM range. Much more docile with the filter but power would come
sooner, bigger filter should cure that.