SmallFry23
NAXJA Forum User
- Location
- Rogue River, Oregon
Hey guys, so i have a 91' with a ax-15 and i replaced my clutch this weekend, and after fighting with stripped bell housing bolts and a seized pilot bearing i go the new pressure plate, clutch disk, pilot and slave reinstalled. I bled the clutch line for about 30 min untill new fluid was showing and the lines were under pressure but my pedal did not have any pressure. i could shift through all gears while pressing and releasing on the clutch pedal simultaneously. i cannot recall if i released the plastic retaining tabs that hold the new slaved compressed, or is it possible they did not release therefore not allowing the bearing to function correctly?
cheers
cheers