Im in the process of wiring up a small switch panel and have hit a road block. Everything will be ran thru appropriate relays after the switches. I have 2 SPST switches , one for my OBA and one for my fog lites those were no problem. The third is not being quite so easy.
It will be controlling a set of Hell 500's on the front of the jeep. I bought the DPDT switch (on/off/on) as I would like foward on the switch to switch the hellas on automatically when the high beams are on.
And back on the switch to run them independently .
I plan on tapping into the high beam circuit under the dash for the trigger wire for it but cant figure out how to wire the switch. Its a contura from OTRATTW.com
Below is the spec sheet that came with the switch.
___________
| |
| 7- |
| 1- 4- |
| 2- 5- |
| 3- 6- |
| |
___________
7 common ground for both lights (switch illumination)
1 outgoing + for lower light
2 incoming +
3 outgoing + for upper light
4 outgoing
5 incoming
6 outgoing
Notes: this is a dual lighted switch with pin #7 being a common ground for the lights. Tabs 4,5, and 6 are not connected internally to the lights.
It will be controlling a set of Hell 500's on the front of the jeep. I bought the DPDT switch (on/off/on) as I would like foward on the switch to switch the hellas on automatically when the high beams are on.
And back on the switch to run them independently .
I plan on tapping into the high beam circuit under the dash for the trigger wire for it but cant figure out how to wire the switch. Its a contura from OTRATTW.com
Below is the spec sheet that came with the switch.
___________
| |
| 7- |
| 1- 4- |
| 2- 5- |
| 3- 6- |
| |
___________
7 common ground for both lights (switch illumination)
1 outgoing + for lower light
2 incoming +
3 outgoing + for upper light
4 outgoing
5 incoming
6 outgoing
Notes: this is a dual lighted switch with pin #7 being a common ground for the lights. Tabs 4,5, and 6 are not connected internally to the lights.