uplandhawaii
NAXJA Forum User
- Location
- Hawaii
Aloha,
I have a problem that hopefully some one will know how to fix. I did a search but couldn't find anything that would help me out.
The clutch in my 92 XJ was starting to get real soft grabbing right off of the floor and getting hard to shift. If I pumped it the pressure would build up and I could drive it for a while. The clutch setup was about 5 years old so I decided to replace it.
I replaced the entire clutch system, master cylinder, hydraulic concentric bearing, pressure plate, clutch disk and pilot bearing and bled the system.
I still have the low grabbing problem. The clutch grabs at a 1/2" off the floor but shifts fine if I put the pedal into the floor. The clutch is a LUK set up.
Is there anyway I can get the pedal to grab further up? Before replacing the clutch it grabbed about 3-4" off the floor.
Any suggestions or ideas would be greatly appreciated!
Mahalo's
upland
I have a problem that hopefully some one will know how to fix. I did a search but couldn't find anything that would help me out.
The clutch in my 92 XJ was starting to get real soft grabbing right off of the floor and getting hard to shift. If I pumped it the pressure would build up and I could drive it for a while. The clutch setup was about 5 years old so I decided to replace it.
I replaced the entire clutch system, master cylinder, hydraulic concentric bearing, pressure plate, clutch disk and pilot bearing and bled the system.
I still have the low grabbing problem. The clutch grabs at a 1/2" off the floor but shifts fine if I put the pedal into the floor. The clutch is a LUK set up.
Is there anyway I can get the pedal to grab further up? Before replacing the clutch it grabbed about 3-4" off the floor.
Any suggestions or ideas would be greatly appreciated!
Mahalo's
upland