rust sucks
installing a 3" RC lift, and its been taking much longer than planned. thank god for angle grinders.
I was going to re-use my rear sway bar brackets, but while loosening the bolt holding the bar and bushing, it just started turning, without un-screwing. I don't feel like dealing with it, so thats that.
My question/problem is that I think the same thing might possibly be happening, or about to happen to the front bolt on the rear leaf springs. I've turned it a bit with a breaker bar, but I didn't mess with it too much.
Any tips/advice for getting that bolt out without messing it up? I'm worried that if i mess it up, and it just spins in place I'm going to have a serious issue. I've already been hitting it with PB.
And someone please tell me the front is easier than the rear :wow:
installing a 3" RC lift, and its been taking much longer than planned. thank god for angle grinders.
I was going to re-use my rear sway bar brackets, but while loosening the bolt holding the bar and bushing, it just started turning, without un-screwing. I don't feel like dealing with it, so thats that.
My question/problem is that I think the same thing might possibly be happening, or about to happen to the front bolt on the rear leaf springs. I've turned it a bit with a breaker bar, but I didn't mess with it too much.
Any tips/advice for getting that bolt out without messing it up? I'm worried that if i mess it up, and it just spins in place I'm going to have a serious issue. I've already been hitting it with PB.
And someone please tell me the front is easier than the rear :wow: