Holy Cheap SYE.....

[georger]

Thanks for the help.

 

[TomMcD]

It's not lke your rear is going to end up getting pitched into the air (thats a myth and is not true( I know for fact)). I

Obviously you didn't see the Myth Busters episode where they did just that. http://mythbustersresults.com/episode27 Absolute worse case scenario in an XJ it could rupture the gas tank. :flame:

But I'm not worried enough about it to not run the set up. In this application if it's going to fail it would be on the trail rather than the highway.

 

[stoneyva21]

Obviously you didn't see the Myth Busters episode where they did just that. http://mythbustersresults.com/episode27 Absolute worse case scenario in an XJ it could rupture the gas tank. :flame:

But I'm not worried enough about it to not run the set up. In this application if it's going to fail it would be on the trail rather than the highway.

yeah but they really really had to try and get that to happen.

i have been running the iro setup for a little while and have no issues. i dont run red's, or have 35's thou.

 

[jmop]

i have been running the iro setup for a little while and have no issues.

x2

I ran a front shaft in the back for quite some time, I know several people doing the same. They are cheap enough to keep a few spares around and just junk when they get wore out or break. I've seen them run with 1 tons and +40" tires and deep gearing without fail. YMMV of course

 

[rockcrawler]

So after doing some research I'll still be fine with the front DS set up on my NP231 with C8.25. I got the front DS but now I need the flange/yoke just like in this picture http://www.csloffroad.com/images/view.aspx?productId=207 Where can I get one, any sites that sell what I need. Also will this here work??? http://www.tellico4x4.com/product_info.php/cPath/2880_1848_1850/products_id/23639

Please help me out I got to get my project out on the road

Thanks a lot

Alex

 

[Gravesdiggerxj]

Cal is just a complainer. front shaft in the rear works fine. .120 wall is plenty. slip spline is small, but if you're breaking that you're gonna need more than 1310 joints soon anyways...

(says the guy running 39.5 tsl's and a 35 spline 60 on a cut down retubed front shaft in the rear)

 

[Tim_MN]

Where can I get one, any sites that sell what I need.

As posted in this very thread, Iron Rock Off Road.com sells that yoke by itself or you can get the yoke and drive shaft.

 

[kastein]

google for 3103-27CV - Six States and drive-line.com both have it. I bought mine from drive-line.com.

EDIT: Either will charge you a lot less than IRO. Like, 40 dollars less - about 2/3rd the price.