freerider15
NAXJA Forum User
- Location
- FoCo, Crawlorado
Don't normally cross post...but I know everyone in the Colorado Chapter doesn't always come in here and vice versa
Alright, so one of the things I still need to do on the buggy is wire up switches for headlights (low/high beam).
I would prefer to have it on one switch (DPDT) that way one way is low, one way is high, and center (neutral) is off. If needed two switches (SPST) could be used.
So here is the FSM diagram below:
SO we have:
- CAV 4, 7 and 8 are Fused B(+) and therefore power
- CAV 2 and 9 are headlamp switch output. One each for L/R, or one each for Low/High?
- CAV 1, 3, 5, and 6 appear to be unneeded.
So Any input as to how one would go about hooking up the headlights?
I'm off to do some meandering through the FSM to try and figure stuff out.
I can grab screen shots of the wiring diagrams if needed as well.
Looking at them now to try and walk through it...
Alright, so one of the things I still need to do on the buggy is wire up switches for headlights (low/high beam).
I would prefer to have it on one switch (DPDT) that way one way is low, one way is high, and center (neutral) is off. If needed two switches (SPST) could be used.
So here is the FSM diagram below:
SO we have:
- CAV 4, 7 and 8 are Fused B(+) and therefore power
- CAV 2 and 9 are headlamp switch output. One each for L/R, or one each for Low/High?
- CAV 1, 3, 5, and 6 appear to be unneeded.
So Any input as to how one would go about hooking up the headlights?
I'm off to do some meandering through the FSM to try and figure stuff out.
I can grab screen shots of the wiring diagrams if needed as well.
Looking at them now to try and walk through it...