Does anybody make an exhaust skid? Before I tore mu exhaust off I measured that it stuck down about 4 inches below the frame and since I've gotten it welded back on it's still sagging that much. Is this normal or should it be up higher? All the hangers are in place and the engine 2 cat pipe is probably about 2 yrs old at the most, the part that sits above the crossmember was dented but the pipe wasn't deformed/reshaped. My digicam's broken so I can't post a pic now, I'll try 2 find an old one.
Any one else have this problem?
Any one else have this problem?