Smash Hole
GFY
- Location
- Smash HQ
After doing my ball joints i decided it would be a good time to put my Lockrite in my D30. I followed the writeup on DPG and got to this point.
So it was time to put the pinion/cross shaft back it, but I cant slide the shaft past the two spacers inside the drivers. The spacers seem to be about an 1/8 too close to each other. Did i do something wrong? I have the fat end of the spacers facing the teeth and the two thrust washers on the couplers.
Any help would be appreciated. I need this thing back on the road by noon tomorrow so if I cant figure out this whole pinion shaft problem would I be okay driving with out the pinion shaft as long as I don't put it in 4?
Thanks a lot.
So it was time to put the pinion/cross shaft back it, but I cant slide the shaft past the two spacers inside the drivers. The spacers seem to be about an 1/8 too close to each other. Did i do something wrong? I have the fat end of the spacers facing the teeth and the two thrust washers on the couplers.
Any help would be appreciated. I need this thing back on the road by noon tomorrow so if I cant figure out this whole pinion shaft problem would I be okay driving with out the pinion shaft as long as I don't put it in 4?
Thanks a lot.