Hi guys, I have just finished pulling my carrier out and doing the inner seals on my d30.
I accidently slipped my mallet when tapping the bearing races into the place and hit the ring gear a couple times.
Can this cause any problems? I am by no means a gear expert and I am starting to feel in over my head on this one.
My other concern is I put my axles back in bolted the hub on and when I spin my axles shafts I get a clicking as from my spider gears? This dosent happen when I am spinning my drive shaft and the whole assembly spins. Is this a concern as well?
Thanks for taking the time to answer my questions.
I accidently slipped my mallet when tapping the bearing races into the place and hit the ring gear a couple times.
Can this cause any problems? I am by no means a gear expert and I am starting to feel in over my head on this one.
My other concern is I put my axles back in bolted the hub on and when I spin my axles shafts I get a clicking as from my spider gears? This dosent happen when I am spinning my drive shaft and the whole assembly spins. Is this a concern as well?
Thanks for taking the time to answer my questions.