SPSERG
NAXJA Forum User
- Location
- Massachusetts
Good Afternoon, My Jeep is finally all back together and being driven daily again. I am very happy with the lift, but my brakes are pulling to the right at slow speed stops. Its mainly just as you roll to a stop, a noticable right side pull, controllable but pulls the wheel. I did not have this problem prior to the lift and front end work. Here is a low-down of my front end work:
2 inch OME coils/ 2 inch budget boost
New adjustable track bar
new lower and upper adjustable control arms (caster set at 6*) Verified
new drag link and tie rod end and adjuster. Wheel is straight
RE heavy duty tie rod and ends
new extended bump stops
RE Extended brake lines, fully bled, front and back. MC FULL, no leaks
Alignment set at 1/16 toe in. Verified with tape measure
tires are 6 months old (BFG AT 30x950) and look fine, pressure OK
Everything torqued to spec.
Ball joints are OK too
I dont think its brake related itself, but I have not pulled off the wheels to check. I put in new wheel bearing about 6 months ago and everything looked very good (Pads, rotors etc)
I am kinda stumped here so any ideas would be great!
2 inch OME coils/ 2 inch budget boost
New adjustable track bar
new lower and upper adjustable control arms (caster set at 6*) Verified
new drag link and tie rod end and adjuster. Wheel is straight
RE heavy duty tie rod and ends
new extended bump stops
RE Extended brake lines, fully bled, front and back. MC FULL, no leaks
Alignment set at 1/16 toe in. Verified with tape measure
tires are 6 months old (BFG AT 30x950) and look fine, pressure OK
Everything torqued to spec.
Ball joints are OK too
I dont think its brake related itself, but I have not pulled off the wheels to check. I put in new wheel bearing about 6 months ago and everything looked very good (Pads, rotors etc)
I am kinda stumped here so any ideas would be great!
Last edited: