XJMark
NAXJA Forum User
- Location
- New Port Richey, FL.
Today I was doing an oil change and as usual I grease all the joints on the front end. Everything goes well until I get to the driver side upper ball joint, it won't accept grease! I took the zerk fitting out and it flows O.K. I put it back in and the grease gun handle won't go down. I started pounding on the handle of the grease gun and grease started going in but very hard, I did manage to get some grease to show at the rubber dust cap.
Is that upper joint fried? I put them in about a month ago. Anyone else run into this?
Mark
Is that upper joint fried? I put them in about a month ago. Anyone else run into this?
Mark