Recent content by RuffedUpXJ

Here is a good diagram how to wire up the OBA as well as plumbing it. Something to remmeber is the compressed air is very hot when intially coming out so PVC or other plastic air hoses will not last long here. I coiled up some copper and made sure there was a couple of feet of it before the...

There is a Charity event going on in Trenton, Ohio; north of Cincy and south of Dayton. Its being put on by CORE and Terrain Stompers. Its benefiting The One Way Farm of Fairfield, it's basically a foster care place for kids who have no parents or relatives and for the more troubled kids. Its...

I have 2 Hellas on the front bumper and then 4 55 watt square lights up on the rack and then 3 facing the back for setting up camp and I still have trouble seeing

They aren't Claws and with the Dana 44's and the alloys you should be fine with spares of course. Beat me to it Will

Nice job I like the tire carrier

How big of meats going to be running 38-39's? I don't think the track bar will be too long. I also dont think you need a new one.

I am running the 3 leaf pack, I am not sure which S10 that is but I have the two leaves in there and not the overload and I have about 4-5 inches. I dont have flares or anything that the flares mounted to so i cant measure.

Here is mine, it was made out of 2"x5"x1/4" tubing and has weld through tabs and a hitch welded through. Also it mounts like a hitch plus the stock bumpers holes so 7 per side.

I would try out the hand throttle, I wheeled by buddies jeep with an manual and i did pretty good just using the hand throttle. It takes a lil practice but you can kinda drive it like a auto. Let the clutch out and set the throttle use the brakes to work a lil. Also if you dont have cruise...

If I were to buy it i would only use it for steering links. So depending on how you set them up you could make 4 good sets of crossover links. The part that the bung fits into the 1.25 x .120 sch is what scares me. I just is too small for suspension links, personally.

Like this

I used a fence latch from Lowes or Home Depot

One of the better ways to center the axle is to have the trackbar off one of the ends(the adjustable one) and get in the Jeep and jerk the steering wheel back and forth a couple of time and let it settle then adjust it to the length that fits.

I ran my 35's BFG's at 28 PSI

Ok Well you need to make some better spring perches since you used 2" square stock to sit a 2.5" wide spring on. Plus that block isnt helping out. What you can do is integrate the block into the new mount by building the spring perch up and going with that. You just need the right size perches...