xjdc12
NAXJA Forum User
- Location
- Oregon/Arizona
Re-posting this here as the local chapter forums haven't responded much. Know we are really in the boon docks, but there might be a decent guy/shop closer then the big cities.
Have a vibration in the rear end after ~1800 miles on my DIY install of new gears etc. in rear end while at home in OR. Looking for a good rear end guy/shop near Quartzite, maybe Parker/Blyth area to diagnose/repair. Not enough tools and equipment with us here in AZ for another DYI. If not there Wickenburg perhaps? Or even recommends for W. Phoenix area?
Thanks.
(Oh yeah- Think it's in the rear axle, as the T Woods CV drive shaft is nice and tight and spins true, nothing loose, pinon angle is ~2.5 down from DS, and all 4 tires just rebalanced and inspected for high spot/failures. It's a 50mph and up rum-rum vibration on pull and deceleration, worse on pull. Almost goes away on light float and getting worse with more miles).
Have a vibration in the rear end after ~1800 miles on my DIY install of new gears etc. in rear end while at home in OR. Looking for a good rear end guy/shop near Quartzite, maybe Parker/Blyth area to diagnose/repair. Not enough tools and equipment with us here in AZ for another DYI. If not there Wickenburg perhaps? Or even recommends for W. Phoenix area?
Thanks.
(Oh yeah- Think it's in the rear axle, as the T Woods CV drive shaft is nice and tight and spins true, nothing loose, pinon angle is ~2.5 down from DS, and all 4 tires just rebalanced and inspected for high spot/failures. It's a 50mph and up rum-rum vibration on pull and deceleration, worse on pull. Almost goes away on light float and getting worse with more miles).