Manuel Shift Issues-rubber boot

C

crazydave

NAXJA Forum User

Location

Saginaw,Tx

• Dec 25, 2006

• #1

The rubber boot at the bottom of the stick is falling apart again and was curious if they are urethane boots or maybe an all steel one like racing cars for the jeep. I did try a search but never found any info I was looking for.

 

C

crazydave

NAXJA Forum User

Location

Saginaw,Tx

• Dec 26, 2006

• #2

I guess I am the only one that had to replace the shift boot. There has to be a better solution than the oem part.

 

R

RCP Phx

NAXJA Forum User

Location

Phoenix,Az

• Dec 26, 2006

• #3

There are tons of boots available out there!Sounds like you dont have the "underside" weather stripping/boot to protect the "interior" boot.

 

ren

NAXJA Forum User

Location

frenchburg, ky

• Dec 30, 2006

• #4

Are you asking about the boot that is under the body, that goes over the hole in the tranny that the shifter sticks out of? If so, try using the CV boot for an import like an older model Nismo Sentra. This works really well on the B/A 10-5 with a couple of hose clamps to make sure that it stays put.

 

old_man

NAXJA Forum User

Location

Loveland, Colorado

• Dec 30, 2006

• #5

I used an aftermarket shift boot from Autozone. It worked great.