randomguy310
NAXJA Forum User
- Location
- kentucky
is it a bolt on deal?
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
98 grand rear disk to xj...bolt on?
- Thread starter randomguy310
- Start date
- Location
- Illinois
Yes for a D35. Not for an 8.25
DeftwillP
NAXJA Forum User
- Location
- Round Rock TX
Technically it is, you just have to grind out the middle of the backing plates a smidge. A die grinder makes pretty quick work of it.
yossarian19
NAXJA Forum User
- Location
- Grass Valley, CA
I'll go with the above ^^
I did this mod on a Chrysler 8.25 using ZJ parts. Had to open up the 4 holes in the mounting flange as well as the center where it slips over the tube. Some report not having to open up the 4 holes, I had to.
On a D35, it all bolts right up.
I did this mod on a Chrysler 8.25 using ZJ parts. Had to open up the 4 holes in the mounting flange as well as the center where it slips over the tube. Some report not having to open up the 4 holes, I had to.
On a D35, it all bolts right up.
- Location
- Salem, OR
My advice if this goes on a 8.25 is the four bolt holes need to be widen towards the center hole as the bolts are grouped just a hair tighter than a d35
Jbh97009
NAXJA Forum User
- Location
- Damascus, Oregon
My 8.25 only required opening the center hole, didn't have to mess with the 4 holes, however it did require longer bolts. That's it.
Parking brake cables are a lot simpler than people make it out to be too
Parking brake cables are a lot simpler than people make it out to be too
- Location
- WA state
If you have a C8.25, KJ Liberty rear disc are plug n pray.
