Hey guys, I found a 1986 MJ with disco front and 4.10's. My current XJ setup is a measley set of 3.07's.
My question is this: With the exception of welding up some spring perches on the rear, is this a total bolt in project?
I can get both axles for $335, or the whole truck for $500. The truck is minus everything involving an engine, but has trans and tcase. Also, a small fire has been in the driver's area which wiped out the dash, guages, seat, and headliner. It's a longbed formerly with a 2.5L also.
Think I should buy the whole thing? Will the rear springs work as some XJ lift springs, similar to the Dogde Dakota leafs?
Any info is appreciated guys, thanks in advance.
Jared
My question is this: With the exception of welding up some spring perches on the rear, is this a total bolt in project?
I can get both axles for $335, or the whole truck for $500. The truck is minus everything involving an engine, but has trans and tcase. Also, a small fire has been in the driver's area which wiped out the dash, guages, seat, and headliner. It's a longbed formerly with a 2.5L also.
Think I should buy the whole thing? Will the rear springs work as some XJ lift springs, similar to the Dogde Dakota leafs?
Any info is appreciated guys, thanks in advance.
Jared