WTB: Front driveshaft from an auto XJ

[BlacknBlue_XJ]

Hey all, looking for a front driveshaft to use when I install a SYE. Preferrably up north (Denver - Fort Collins). Whatcha got?

 

[Starboard M]

Last time I looked the junkyards were full of those things, but this one did just pop up on clist (Im not the seller, no affiliation).

http://denver.craigslist.org/pts/5588055980.html

$50

I dont think the '00 and '01 ever came in a manual, so it should be an auto dshaft.

 

[BlacknBlue_XJ]

Thanks for the heads up. It's hard for me to make time to get down there and check them all out. I may grab that craigslist one if noone closer chimes in.

 

[Boostwerks.com]

I've got an aftermarket with very low miles. $80 maybe? I'm in Loveland.

 

[puttzer]

I've got an aftermarket with very low miles. $80 maybe? I'm in Loveland.

Bryson, I will take the driveshaft if OP does not want it.

 

[BlacknBlue_XJ]

I'm at ~2 inches now and will be about 4 all said and done. Will the aftermarket shaft fit that? I've done a little research but can't find a definitive answer on what length I need past "from an auto xj."

 

[1-tonxj]

The slip yoke on the the drive shaft can be bought in different lengths it just pulls off the stub shaft an another slides back on so a stock front shaft can be made longer by a couple inches just by swapping the slip yoke .

 

[BlacknBlue_XJ]

What are the collapsed and extended lengths?

 

[1-tonxj]

The pair I have are both 33 collapsed and 36 and 37 extended new they are 1310 cardans and .188 wall.

 

[BlacknBlue_XJ]

Sorry for the delay in response. Puttzer, it's all yours. Best I can tell I will need a stock length.