moparcyco
NAXJA Forum User
- Location
- Preston Idaho
Question 1.Is it possible to set pinion angle i.e. tack perches onto a bare housing without the xj on it's own weight? I thought it might be easier to handle before I get the gears and lockers and hubs installed. Or am I way better off setting it up fully then set the perches? I have some wheels and tires for mockup could I just set the hubs in the center of the wheels and let the rig down this way? This is my first custom axle install just trying to make it as smooth as possible.
Question 2. To center the rear axle properly you need to just make sure that the backing plates or backside of plates is the same measurement from the outside of the leaf springs on each side? Even though the axle is not equal side to side the passenger tube is a bit longer. This is what I have come up with searching is there a better way? As always thanks guys
Question 2. To center the rear axle properly you need to just make sure that the backing plates or backside of plates is the same measurement from the outside of the leaf springs on each side? Even though the axle is not equal side to side the passenger tube is a bit longer. This is what I have come up with searching is there a better way? As always thanks guys