drumnerd33
NAXJA Forum User
- Location
- colorado springs
ok well i finally got my rear axle done (ive rebuilt both axles completely) and i did the shackle relocation brackets by hd offroad engineering... they are bad ass... but they gave me an extra inch of lift and i needed 2, so i got lift shackles and its perfect............ except my axle angle is so high that my pinon to driveshaft angle is almost going at the wrong angle,
my full build is under drumnerd33 noob build if you wanna look at it, but anyways my thought was to take the shims i have and use them to lower the angle of the pinon, so basically use them the opposite of what they normally would do like raise the angle, any advice is greatly appreciated... and no i dont have the money right now to put in a slip yoke eliminator.. thanks
my full build is under drumnerd33 noob build if you wanna look at it, but anyways my thought was to take the shims i have and use them to lower the angle of the pinon, so basically use them the opposite of what they normally would do like raise the angle, any advice is greatly appreciated... and no i dont have the money right now to put in a slip yoke eliminator.. thanks