GravityKitty
NAXJA Forum User
- Location
- Pennsylvania
Hello everyone! I recently got my first Jeep, a 1995 XJ, earlier last month. While I was getting my front hub and bearings replaced, my boyfriend noticed that there was a rusted area where the spring attaches to the axle.
This makes an awful noise if I take a left turn a little too hard. I was wondering what I should do about this. Does this require a full axle replacement, or would I be able to just replace the housing?
My XJ has a 4.0 engine, it's automatic, and it's 4WD. Also, everything seems to be stock. I apologize for not being able to tell you what axle I have in the front, but I would assume it's a Dana 30. I don't know much about Jeeps (or cars for that matter) yet, but I'm willing to learn and appreciate any help that you guys can offer! I can also take more pictures later, if needed. Thanks!
This makes an awful noise if I take a left turn a little too hard. I was wondering what I should do about this. Does this require a full axle replacement, or would I be able to just replace the housing?
My XJ has a 4.0 engine, it's automatic, and it's 4WD. Also, everything seems to be stock. I apologize for not being able to tell you what axle I have in the front, but I would assume it's a Dana 30. I don't know much about Jeeps (or cars for that matter) yet, but I'm willing to learn and appreciate any help that you guys can offer! I can also take more pictures later, if needed. Thanks!
Last edited: