Just to update the thread in case someone is ever in my boat. After two trips to store for resistors I ended up not needing them. I had been driving the jeep around my property the past few weeks after getting it running. But only at very low speeds and the speedo didn't appear to work. Today I got insurance and plate sticker and took it out on the street before I managed to wire in the resistor. The speedo starts working fine once I get up to about 15 mph and above. Good enough for me! Thanks again to Kastein for his help. Short shaft 300 really is no big deal to swap in, just a $25 stock part to get you going.
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
run ok without speed sensor
- Thread starter jonzer12
- Start date
- Location
- Rainy side of Washington
330 is way lower resistance than I'd go with, but if it didn't melt the sensor, it won't hurt anything else.
Glad you got it working!
Glad you got it working!
