I just picked up a rear driveshaft from a '99 XJ
After I brought it home, I looked at the front part, the slip yoke, and saw that the splined hole was completely through, no bottom, open all the way to the U Joint.
That surprised me because I am pretty sure that last time I had the driveshaft off my '96 and I was greasing the splined hole there was a bottom to the hole.
Did the slip yoke design change some time between '96 and '99?
Normally I'd crawl under the Jeep and check the '96, unfortunately I can't, I just hurt my foot.
So, I was hoping that somebody can give me the information so I won't have to wait till the foot gets well.
Thanks.
After I brought it home, I looked at the front part, the slip yoke, and saw that the splined hole was completely through, no bottom, open all the way to the U Joint.
That surprised me because I am pretty sure that last time I had the driveshaft off my '96 and I was greasing the splined hole there was a bottom to the hole.
Did the slip yoke design change some time between '96 and '99?
Normally I'd crawl under the Jeep and check the '96, unfortunately I can't, I just hurt my foot.
So, I was hoping that somebody can give me the information so I won't have to wait till the foot gets well.
Thanks.