xj92
NAXJA Forum User
- Location
- Junction City, KS
How much play should there be between the axle and the hub assembly (D30) if the hub is tightened down but the axle nut is not on yet? I've got almost 1/4" (just by eyeballing it anyways) and after I tighten the axle nut down, it pulls the axle shaft out a little bit and then gear oil seeps out the end of the tube, so I'm assuming that since the axle is tapered right after where it goes in the seal it must not be in far enough and not sealing. Anybody with experience on these?