recycledxj
NAXJA Forum User
- Location
- baltimore
So about 4 years ago I installed a lockrite in a factory 4.10 geared dana 35 that was non c clip. The lockrite was for a c clip axle but no big deal as I remember it was a very easy job. Then I had a leak and ran out of gear oil and locked the rear end up solid, broke everything free installed new gears and bearings. Now 4 years later I'm getting rid of the axle and I am taking the lockrite out of the carrier and it refuses to be removed. I have the carrier out, the center pin out and the small springs and pins out but it doesn't want to go.
It is possible the carrier expanded from the excess heat when I ran out of gear oil. When I rebuilded the rear I didn't have to remove the locker at all. I don't know.
It is possible the carrier expanded from the excess heat when I ran out of gear oil. When I rebuilded the rear I didn't have to remove the locker at all. I don't know.