Jimminyc
NAXJA Forum User
- Location
- GJ, Colorado
Im drilling out my knuckles and going with 3/4 heims on some pipe and it was brought to my attention that there may be a special tapered bolt i will need to use that will take up the slack in the already tapered knuckle to properly convert over. Im just going to run both the drag link and tie rod onto the pass side on top of the knuckle. I was thinking that a bolt with a tapered head to fit into the hole would be stronger in the end, but im not sure where to find one.
Has anyone done this conversion with/without a tapered bolt?
How did it work out for you?
Would grade 8 be best for a single shear setup like this?
should i just drill it out and not worry about a special bolt?
Thanks!
Brian
Has anyone done this conversion with/without a tapered bolt?
How did it work out for you?
Would grade 8 be best for a single shear setup like this?
should i just drill it out and not worry about a special bolt?
Thanks!
Brian