xalexjx
NAXJA Forum User
- Location
- Newcomb, NY
I was going to buy the RK setup but figured hiems would be just as good and cheaper. What are you guys running on the d30 stock knuckles?
Plans so far
1.5" .25 wall tubing
weld in bungs
3/4" male chromoly heims for the knuckle side. What size hole can you safely drill in the d30 knuckle? 5/8"? Im going to drill the knuckles out to that side and run a grade 8 bolt through it with the nut side up. Use a nut to tighten it to the knuckle. The put the heim on that then another nut on the top and tighten each on individually. Is it better to run the drag link from the knuckle to knuckle tie rod or off from the passenger side knuckle. Thanks In advance.
Also any pictures of how you guys have them set-up?
Plans so far
1.5" .25 wall tubing
weld in bungs
3/4" male chromoly heims for the knuckle side. What size hole can you safely drill in the d30 knuckle? 5/8"? Im going to drill the knuckles out to that side and run a grade 8 bolt through it with the nut side up. Use a nut to tighten it to the knuckle. The put the heim on that then another nut on the top and tighten each on individually. Is it better to run the drag link from the knuckle to knuckle tie rod or off from the passenger side knuckle. Thanks In advance.
Also any pictures of how you guys have them set-up?