lickdj
NAXJA Forum User
- Location
- Abbotsford , B.C , Canada
Hey guys I was hoping to get some help from some of you fender hacking pro's and i know there are alot of you out there. Im having trouble on the front fenders on the back part of them near the pinch seam here is a picture of where I am at. I need to go back more however now i believe im heading into problems with the pinch seam and the fender screws. I was thinking just put a few more screws in the lower part where the fender joins the body and then i can go back further and take out the stock fender screw. However my big problems is that hole im not sure if i should but cutting that whole seam or should i bend it over.
I currently have roughly 5" of lift minus saggage. I'm trying to clear my Brand new 33" baja Claws. I have a Full Traction 6" lift on the way however that wont be for 2 weeks and I have no other choice but to work with this setup until that arrives. And if I can clear the fenders for the current lift that means when the new lift comes I should be problem free when it comes to flexing or so i hope.
I currently have roughly 5" of lift minus saggage. I'm trying to clear my Brand new 33" baja Claws. I have a Full Traction 6" lift on the way however that wont be for 2 weeks and I have no other choice but to work with this setup until that arrives. And if I can clear the fenders for the current lift that means when the new lift comes I should be problem free when it comes to flexing or so i hope.
Last edited: