ARBOGASTER
NAXJA Forum User
- Location
- Cincinnati OH
I put a SYE on my 1996 and have moved my front shaft to the back. I am currently without a front shaft and need to remedy this problem. I have two bronco driveshafts with double cardan joints that I would like to use. The length looks like it would work. I think they are 1330 joints though instead of 1310. I was just going to put a 1310/1330 cross at the axle, It doesn't look like I could do that at the CV joint end though because I don't think it would bolt up to the yoke at the transfer case. Does anyone make a 1330 yoke for the NP231 either for the front stock output shaft or for the rear with the heavy duty spline from the SYE. I'd like to put a dual cv joint shaft on the front but that would require a 1330 pinion for the dana 30 as well as the transfer case. That would be the ideal setup though.