I'm honestly stumped on this project. I just got done sealing the case, adding fluid, and going on a test run with the new 2Low. The one big problem I immediately noticed was not being able to get it into regular two wheel drive. I can get 2Low sometimes, but it's definitely picky.
I loosened the trunnion nut, and adjusted the linkage best I could. I don't think that's the problem. It also takes a lot of force to get it into 4low and 2low, and barely any to go from what should be 2hi to 4hi.
I'm thinking something must not have been installed correctly? Before I rip the case out, and crack it again, does anyone have suggestions?
The only thing I can think of besides the linkage, is maybe I installed the synchro/mode sleeve backwards. I remember installing the long side to the front, which I believe is correct.
What am I missing?
I loosened the trunnion nut, and adjusted the linkage best I could. I don't think that's the problem. It also takes a lot of force to get it into 4low and 2low, and barely any to go from what should be 2hi to 4hi.
I'm thinking something must not have been installed correctly? Before I rip the case out, and crack it again, does anyone have suggestions?
The only thing I can think of besides the linkage, is maybe I installed the synchro/mode sleeve backwards. I remember installing the long side to the front, which I believe is correct.
What am I missing?